View Full Version : Hello from Texas!
03-09-2007, 08:05 AM
I have a Wishblade and I'm new to this forum. I'm so excited because I was wanting to weld words, and I used information off this site to do it. The only problem is....I have a full sheet of welded words that I need cut and my WB stops after the fourth one...ugh... The power light starts blinking, so I have no idea what's wrong. I tried it again and it stopped in the same place.
03-09-2007, 09:06 AM
Janna, I answered this question in the other area where you asked it, so refer to it, so I don't have to type again!
We are happy to have you! Glad you are getting use out of the tutorials! They are awesome!
I just got back to Texas after leaving temporarily for 7 months! It is great to be back to warm weather! I live 30 miles SW of Fort Worth!
Powered by vBulletin™ Version 4.0.8 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.