My WB Stops cutting in the middle of a job.

[jannao]

I used the instructions on converting letters to welded words thru inkscape (thanks btw for the instructions) My problem however is that I have an 8.5 x 11 page of small cutouts. After about 4 welded words, my WB stops cutting and the power light starts blinking. I restarted another sheet and it stopped again in the same area and the pwr light started blinking again. Anyone have any ideas as to why this is happening?

Txs!
Janna

[Shirley803]

Not to worry Janna. It is just thinking! If you wait (sometimes it thinks for a quite awhile), it will start cutting again. It just gets overloaded with information, so it takes time out to think before proceeding. It seems like I waited for 10 mins one day, then it kicked back in and started cutting!

Shirley

[jannao]

Hmmm..not sure it will ever start back. I left it cutting over night and it didn't ever start back. Crazy

[Paperthreads]

THis is a memory issue. Shut down the computer and start over. Copy and paste the cuts into a new document and try that.

Or, put less on a page, cut, then put the rest on the page, and delete your original stuff, and cut again.